Website map|Add to favouritesWelcome to Ahead Technology(Shen Zhen) Co.,LTD

AHEAD product
Current location: Home»AheadMold News » Ahead News » Plastic Mold Apprearance Check

Plastic Mold Apprearance Check

Categories: Ahead NewsStars: 3Stars Visit: - Release time: 2015-12-31 10:23:00
Font size:【 Large Middle Small Source: Editor:

Plastic Mold Apprearance Check --- Aheadmold

1,Mold surface is free of pits, rust, extra unused rings, water fitting, gas, other defect which affect the appearance of the hole, etc.,
2,more than 1.5mm chamfer on all mold plates.
3,the cooling fitting should be upper than the mold surface, and is better to locate in unoperate side
4 every lift ring should be marked their size if their weigh over 10 kg,or make sure the friendly use.
5,make sure supporter is higher than blocks by 0.05-0.15mm.
6,all cooling should be marked “IN” and “OUT”,adding sequence number if needed, such as IN1, OUT1, IN2, OUT2.
7,Each plates should be marked with datum symbols and numbers ,position at 10mm away from the edge, writing should be clear, beautiful, neat, spacing evenly.
8,Small molds must have lifting holes in A plate and B plate, all plates of large mold must have lifting holes.
9,All four corners of the mold shold have pry slot between two plates.

Article come from China injection tools manufacturer - AHEADMOLD, website is WWW.AHEADMOLD.COM.

Previous page:Rapid PrototyingNext page: Injection Mold Design

CONTACT

Ahead Technology(Shen Zhen) Co.,Ltd No.36 Shiwei Pinggang Industrial Area, Jiangshi Community,Gongming Street, Guangming New District, Shenzhen, China 518106

Phone: +86-755-23426229

Fax: +86-755-29904981

E-mail:tina@aheadmold.com

Stay in Touch

Sign up for our newsletter to receive event updates and exclusive offers

  • Email Address:
  • Leave your words here: